Ergonomic height-adjustment table – SL
Designed for loads of 500, 1,000 or 1,500 daN. This range, some models of which can be fitted with safety bellows, has been specially designed for workstation layout requirements (palletising, inspection, order picking, packaging, etc.).
Optional or specific equipment
- Corrosion protection by hot-dip galvanising.
- Design and components for installation in ATEX zones.
Lift table - SL series
- Platform made of folded smooth sheet steel on all models.
- Flat bar scissors on all models.
- Single-acting hydraulic cylinders with chrome-plated steel rods.
- Maintenance-free joints, bearings and rollers, designed for a maximum of 10 cycles / hour, 8 h / day, 5 days / week.
- Electro-hydraulic power unit, external / built into the equipment.
- External electrical cabinet for a 230 / 400 volt three-phase 50 Hz power supply, connected to the lift table by 3 m of cable.
- Up / down / emergency stop controls via a push-button box supplied
at 24 volts and connected to the electrical cabinet by a 3 m cable. - Limit, safety and position switches … mechanical type with IP 65 plastic housing.
- FR-N05-VV5-F series electrical cables.
- Finishing paint: Grey 7043.
- Dual hydraulic safety system, with a pipe-rupture valve built into the hydraulic cylinders and an electrically pilot-operated check valve at the base of the cylinder, to hold and lock the platform in position in the absence of electrical power and in the event of an accidental pipe rupture.
- Factory-set pressure relief valve to prevent the lifting of a load exceeding 1.1 times the rated capacity of the lift.
- Fixed upper limit switch; it automatically stops the platform rising at maximum travel.
- Safety frame beneath the perimeter of the platform, stopping the platform’s descent if it encounters an obstacle.
- Up/down controls with mushroom-head emergency stop, supplied at 24 volts.
- Fold-down maintenance prop, allowing the table to be held mechanically at a fixed height for maintenance.
- Systematic inspection and testing of every lift table before dispatch.
- The design and construction of these standard lifts comply with the European Machinery Directive 2006/42/EC.
- All these models are supplied with CE marking
- Foot pedal up / down control instead of the push-button box. The mushroom-head emergency stop button is then located on the front of the electrical cabinet.
- Safety bellows for models:
SL 05-1410, SL 05-1412, SL 05-1610, SL 05-1612, SL 10-1410, SL 10-1412, SL 10-1610, SL 10-1612, SL 15-1410, SL 15-1412, SL 15-1610, SL 15-1612
